描述
HIKVISION DS-3T1506HP-EI-UPS 4 Port Gigabit Smart Managed Industrial Solar POE Switch 係海康威視網絡交換機，多數用嚟帶鏡頭 PoE。香港防盜為安裝商及經銷商。口數同 PoE 功率以原廠規格為準。
DS-3T1506HP-EI-UPS
4 Port Gigabit Smart Managed Industrial Solar POE Switch
香港防盜為安裝商及經銷商。規格以原廠 datasheet 為準。
- General
- Net Weight0.7 kg (1.54 lb)
- Gross Weight1.16 kg (2.56 lb)
- Dimensions (W × H × D)158.00 mm × 44.00 mm × 130.00 mm (6.22” × 1.73” × 5.12”)
- Operating Temperature-40 °C to 75 °C (-40 °F to 167 °F)
- Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
- Operating Humidity5% to 95% (no condensation)
- Relative Humidity5% to 95% (no condensation)
- Power Supply12V DC, 10A or 24V DC, 5A; 54V 2.22A
- Installation ModeDesk-Mounted,Rail,Wall-Mounted
- Max. Power Consumption120 W
- Power Consumption in Idle2 W
- Surge Protection6 kV
- ShellMetal material, IP30
- Network Parameters
- Ports4 × Gigabit PoE port,2 × Gigabit fiber optical port,1 x RS485 port
- MAC Address Table2 K
- Switching CapacityWhole-Device Performance: 14 Gbps Port Performance: 12 Gbps
- Packet Forwarding RateWhole-Device Performance: 10.42 Mpps Port Performance: 8.93 Mpps
- Internal Cache1 Mbits
- Software Function
- Long RangePorts 1 to 4: up to 300 m. Long range performance may vary depend on camera model or cable condition.
- Port IsolationPorts 1 to 6: port isolation mode to improve network security Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
- PoE WatchdogPorts 1 to 4: auto detect and restart the cameras that do not respond.
- Link AggregationLink aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 2 aggregation group(s).
- Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default. Support 802.1D STP. Support 802.1w RSTP. Support G.8032 ERPS.
- QoSQoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance. Support port-based priority configuration. Support SP, WRR priority schedule mode.
- VLANVLAN is used for network scale planning and network health improvement. Support 802.1Q. Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 4094 VLAN.
- HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. 3. Display the PoE power usage. 4. Display topology information. 5. Display the alarm status. 6. Restart ports and devices. 7. Enable port long-rage mode. 8. Remotely upgrade the device.
- System MaintenanceSupport device management via web. Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses. Support Super IP, which is a fixed IP address (10.180.190.200) for direct access. Support management via Hik-Central Pro. Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Support 802.1ab LLDP for peer device discovery. Support port mirroring for fault locating.
- DHCP SnoopingDHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.
- DDM (Digital Diagnostic Monitoring)Support real-time monitoring of key parameters in optical modules, such as operating temperature, operating voltage, operating current, and Rx and Tx optical power.
- PoE Power Supply
- PoE StandardPort 1: IEEE 802.3af, IEEE 802.3at, IEEE 802.3bt Ports 2 to 4: IEEE 802.3af, IEEE 802.3at Ports 3 to 4: support passive PoE, 24 V or 54 V output depending on DIP switch settings
- PoE Power PinPort 1: 8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-) Port 2: End-span: 1/2(-), 3/6(+) Ports 3 to 4: 8-pin power: 1/2(-), 3/6(+), 54 V output ; 4/5(+), 7/8(-), 24 V output
- PoE PortHi-PoE: Port 1 PoE: Ports 2 to 4
- Max. Port PowerPort 1: 90 W Ports 2 to 4: 30 W
- PoE Power BudgetDC 54 V input: 110 W DC 12 V~24 V input: 60 W
- Approval
- EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
- SafetyCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368-1: 2014+A11: 2017)
- ChemistryCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)
